Electrical drafting services for contractors and plant owners

You do not need to buy a switchboard from us to use our drawing office. Our Invercargill drafters prepare as-built drawings, update site drawings after changes, redraw paper and PDF drawings in CAD, and draw new boards for others to build.

Drafter working on a switchboard layout in CAD at the CWS drawing office

Drafting for other companies, not only our own boards

Much of it is for electrical contractors: as-built sets after site work, repeated updates to distribution board drawings at a port, kiosk and pump station drawings for water treatment plants, solar site drawings, and mechanical services as-builts for a hospital.

The same drafters draw every CWS switchboard, so the drawings read the way a switchboard builder and an installer expect.

Completed three-section Simotrol motor control centre in the CWS workshop
A CWS-built motor control centre. The same office draws every board we build.

What we draw

As-built drawings

After installation or site changes we bring the set into line with what is there: single line diagram, schematics, layouts and schedules. Send marked-up prints, photographs or site notes.

Drawing updates and mark-ups

Extra circuits, a changed feeder or a new revision. We work on your drawings or ours and return the set with the revision recorded.

Paper and PDF to CAD

Old paper, scanned or PDF drawings redrawn in CAD, so they can be edited and reissued.

New board drawings

A full drawing set for a board someone else will build or install.

Sheets in a typical drawing set
The set is agreed for each job. Not every board needs every sheet.
SheetWhat it shows
Cover sheetBoard ratings and characteristics, drawing index and revisions.
General arrangementFront view, dimensions, door layout and cable entry.
Single line diagramSupply, protection devices and outgoing circuits.
SchematicsPower and control circuits, interlocks and terminals.
Circuit schedulesEach circuit with its device, rating and destination.
Label scheduleLabel wording and sizes, ready for engraving.

Formats and standards

DWG and PDF as standard, and EPLAN where the project calls for it. Send your title block and drawing standard if you have them. If not, we draw to a generic one.

Drawings for boards we built

Our drawing register holds about 14,900 drawing files going back to 1988. If CWS built your board, we may still hold its drawings. Send the job number from the nameplate.

Need the design checked, not only drawn? See switchboard design and drafting.

Electrical consulting and switchboard design services, Clive Wilson Switchboards NZ

Drafting questions

Do we need to be buying a switchboard from CWS?

No. Drafting is available as a service of its own, for boards built by anyone.

What do you need from us?

The existing drawings in any form, marked-up prints or photographs showing the changes, and the standard you want followed. We work from what you send, so clear photographs and mark-ups matter.

What formats do you supply?

DWG and PDF as standard. EPLAN projects where the job calls for them.

Can you draw to our title block and standard?

Yes, if you provide them. Otherwise we use a generic title block and drawing standard.

Do you hold drawings for older CWS switchboards?

Often. The register holds about 14,900 drawing files going back to 1988. Send the job number from the nameplate and we will look.

Do you check the design as well?

Drafting records what you specify. If you want ratings, protection or layout reviewed, say so and we scope it as design work.

Send your drawings

Send what you have: drawings, mark-ups, photographs and the date you need the set back.

IP Geolocation by DB-IP · CC BY 4.0